Wheaton, IL Sewer & Air Duct Repair

Cleaned sewer line from outside cleanout upstream to overhead cleanout in basement and got measurements in preparation for sewer lining. 3-25-2025: lined sewer from 4” overhead stack in basement 42’ downstream starting liner in 4” cast just downstream of overhead stack tie in and ending in 6” pvc downstream of 6” pvc outside clean out. Reinstated 6” pvc outside clean out.

2-24-2025: clean and measured sewer in preparation for lining from 6” pvc clean out in parkway 15’ to city main, ending liner just short of city main. 2-24-2025 Inserted a 6” liner through the existing outside clean-out extending approximately 15 feet to just before the city main.

Televised sewer from n overhead clean out in basement oout to city main. Wit provide proposal for installing liner through verhead and ending in pvc just downstream of outside clean out

Televised ducts under slab floors. Ducts in main portion are mostly metal with a portion of a balance run. That is cardboard. Metal is rusted and needs to be spin cast mortared to restore structure. Ducts in addition are in better condition. After the spin cast mortaring the entire system system should be spray lined with Duct Armor duct lining material.

Televised underground air ducts. Galvanized ducts are heavily rusted and deteriorated allowing white powder to enter the ducts. Will send estimate to mortar and line the ducts.

Cleaned 2” cast from laundry to open hole 12’, also cleaned 2” cast from open hole to where ties into 4” 20’. Lined 20’x2” from open hole to near toilet, also lined from open pipe near laundry 12’ to open hole, epoxy coated end of 2” inversion liner to 4” near toilet, also epoxy coated from toilet collar 3’ to liner from previous company.

Televised sewer from outside clean out 15 ft to city main. Provide proposal for lining.

Televised sewer from inside clean out in basement approximately 128 ft to city main. Cast iron under basement floor is very scaled and not allowing things to flow as much as they should. Recommend the installation of an outside clean out to allow for proper descaling of pipe and possible lining if necessary.

Cleaned all underground duct work in preparation for Trenchless casting. 11/13/24 Applied Trenchless spincast mortar to all underground ductwork and furnace 11/15/25 applied first coat of Duct Armor to all registers, plenum and duct runs. 11/22/24 Applied second application of duct armor to all underground ductwork and furnace box.

Televised ducts under slab floor. Ducts in living room is rusted through but the reminder of the ducts do not appear to be rusted. The run leading to the furnace from the living room is crushed in the garage area and would need to be duct up and replaced. The rest of the system can be spray lined with Duct Armor duct lining material.